Wire feeding system of automatic nail making machines
feeding wire pedestal800 is fastened
in the form of the body100 with screw 803.The one side of draw bar 804
is linked with feeding wire eccentric disc202, the other side of which
is linked with transmission arm805.And the other side of transmission
arm is connected to clamping slide801.When crank shaft spinning, feeding
wire eccentric disc202 spins with it. Meanwhile it drives draw bar804
to move back and forth, which impels transmission arm805 to move around
806,and brings along clamping slide801 sliding back and forth to feed
wires.
Pulling feeding control handle802 can control feeding and make it stop anytime during running.
Adjusting the angle of feeding eccentric disc202 can change the feeding time.
Adjusting bar201, resting on feeding eccentric disc, can get different wire feeding length.
Adjust the length of silde804 can get different places, where feeding wire slide moves.
With
adjusting the position of slide807, the feeding wire shears mark can be
regulated to nail cap or nail head, which realizes no shears mark on
the nail body.
Read More: https://www.cnwirenail.com/nail-making-machine-2.html
